I am vaping on a
PeeWee (RN-4081) too, and I have been filling my cart with juice for the past few days. i am cutting the 36mg non flavored from
totallywicked with a 1/5/9/85 mix. 1 part flavoring from
lorannoils.com/5 parts propylene glycol/9 parts Glycerol (Glycerin)/85 parts juice. Gives pretty good vapor and im still getting pretty good nicotine levels. I am also filling my carts with Morning Glory Low Loft Quilter's Polyester Batting (.25") from wally world. Its gonna last me a life time! It's kinda messy when you first try and stuff it in however, I've found a solution.
1. If you take it and unroll about a foot and cut it off.
2. Fold it in half and sandwich it in between 2 towels.
3. With Iron set on high, iron evenly for 20 to 30 seconds.
What this does is take out most of that fluff and kind ah fuse it all together.
4. Without unfolding it cut out a .5"X.5" square.
5. Place Poly into cart.
Ironing it makes it almost the exact same consistency as the original fill.
I have about 1,000 squares cut out, which I used a large paper cutter to do, and i have about 60 carts filled with my juice. I carry around about 7 carts just in case.
The atomizer i have been cleaning by just boiling in distilled water, letting it dry and then giving it a quick blow. I maybe a lot of work but I seem to be getting a system down so that it only takes me about an hour ah week to maintain.
I get good vaper with my mix and the 30ml bottle after cutting, is going to last a while. I too use a lot of those carts.
As for the battery, I am also getting only about 3 hours for a charge because i think i puff on it too much. I am working on a modification for a battery pack. Im hoping it will not make the current battery casing bigger, but i hope to have an end cap that will allow me to just pop in a new battery when i need a new one. This way i can have a 4 slot battery charger, charging 4 batteries at once without the cost of having to constantly buy new ones from an e-cigarette retailer.