Originally Posted by tek

hay bro, so yea the 16 dollar board i am using for 2 4 amp 26650s. i have them out put at 8 volts off my meter. now the reason is i find it easier to just jack in a wall wart or a dc power jack and charge the two cells in the mod. it works just like i want and you can find them from china cheaper. <altho i am still looking, but i was told> so thats why i use em..
not sayin the 3 pin connectors are bad, but my imrs use this board as a over charge and discharge protection. that way i cant drain the bats to the point where the cells would flip.. but hay bro thats just me

Originally Posted by JohnnyJames

It's just a few of the specs seem rather confusing.

specially designed for 7.4V Li-Ion / polymer Li-Ion Battery pack with 20A discharging rate.

Must wait 30 minutes after fully charge to allow the pack to perform balance function before using.

To achieve balance, each cell in battery pack must have equal voltage within tolerance of 0.2V. After charger LED turn Green, unplug charger and wait 30 minutes before use. This is for the pack to perform balance function.

If you want to use this pcm for a battery that is rated less than 20A drain, you must add additional protection device to protect the battery itself. Such as: proper rated polyswitch.

Wouldn't have a clue as to how to set this up properly.